Installation Guide
7
PROBRITE.COM
Please call 1-844-507-5651 or email support@probrite.com for further assistance.
6
Visit www.probrite.com/install for installation video tutorials and product support
AA
x3
Conduit Pipe
Installation (continued)
3A
Mounting Direct Surface/
Junction Box
☐ Mark mounting holes on the surface
of the wall or ceiling (outside of the
internal junction box, if applicable)
☐ Pre-drill holes into the mounting
surface
☐ Make electrical connections per the
wiring instructions below
☐ Use suitable screws/bolts for the
mounting surface (screws provided by
others)
☐ Place gasket (CC) between the fixture
and mounting surface
☐ Secure the fixture by tightly screwing it
into the surface firmly
☐ See step 7 for chualking instructions
AA
x3
Screws
(Provided by
others)
Installation (continued)
Internal Junction Box
Follow Instructions Below for Pendant Mounting
3B
Pendent Mounting
☐ Make electrical connections (see
diagram on page 7)
☐ Insert the wires into the fixture's
junction box
☐ Insert a threaded 1/2" conduit pipe into
the 1/2" conduit entry at the top of the
fixture's junction box
☐ Place silicone sealant around the
conduit and entry for a water-tight
seal
Wiring instructions
☐ If necessary, strip 3/8" of insulation
from junction box or fixture (A) wires
(fig 1).
☐ Connect fixture black wire to house
black wire, the (+) line, and fixture
white wire to house white wire, the (-)
common by twisting the exposed wires
together and using the wire nuts (AA).
Ensure no loose wires.
☐ Connect house ground wire to the
green fixture ground wire, by twisting
the exposed wires together and using
the wire nuts (AA).
LIGHTING
FIXTURE
(+) LINE
(-) COMMON
GROUND
BLACK
WHITE
GREEN
(fig 1).
4A/B
Electrical wiring
TIP: Hold stripped ends near each other and
align any frayed strands (do not twist wires).
Push the wires into wire nut (BB) and use your
fingers to twist the wire nut clockwise until tight.
Check for tightness by pulling wires.
TURN PAGE
For Side Entry Conduit Mounting
CC
Follow Instructions Below for Direct Surface Mounting








