Installation Guide

9
PROBRITE.COM
Please call 1-844-507-5651 or email [e-mail] for further assistance.
8
Visit www.probrite.com/install for installation video tutorials and product support
CC
A
B
Installation (continued) Operation
7
Mounting the light
fixture
8
Caulking around the
light fixture
If Light does not turn on:
☐ Verify that the power is turned ON from the circuit breaker and wall switch.
☐ Verify the wiring for the fixture is done properly.
☐ Verify the line voltage is correct.
If Light flickers:
☐ Do not wire to a dimming switch, use a standard ON/OFF switch
C
C
NOTICE: Failure to properly caulk around the
surface and mounting plate (C) could lead
to water damage and is not covered under
warranty.
NOTE: When attaching this fixture (A) to an
external, surface mount junction box, caulk the
inside of the light fixture before attaching to
the mounting plate (C).
Care and Cleaning
Troubleshooting
Wall Mount
Wall Mount
CC
A
B
Ceiling Mount
Ceiling Mount
☐ Once the fixture is wired, place the light
fixture (A) onto the mounting plate (C)
so the top sloped grove on the plate
rests on the top sloped grove on the
back of the fixture.
☐ Tighten the mounting plate by
tightening bolt (B) back through the
hole on the bottom of the fixture (A)
until the bolt firmly pushes against the
mounting plate (C).
☐ Once the fixture is installed, turn power
back on from the circuit breaker and
switch.
☐ Flip switch ON and OFF to ensure light
functions properly.
☐ Caulk around the mounting plate (C)
and surface with silicone sealant (not
included).
☐ Shut o main power supply before cleaning the product. To prolong the original
appearance, clean the light fixture with clear water and a soft, damp cloth only.
☐ Do not use abrasive cleaners or cleaners that contain alcohol. Do not apply paints,
solvents, or any other chemicals on this light fixture. They could cause a premature
deterioration of the finish and may void the warranty.
☐ Do not spray the light fixture with a hose or power washer.
Switch-controlled operation enables the light fixture to turn ON and OFF by
flipping a standard light switch. To add automatic Dusk to Dawn control or
motion sensing external sensors like a photo-control, motion-sensor or timer is
required (sold separately).
SWITCH-CONTROLLED
C
Ceiling
Junction Box
C
Wall
Junction
Box
NOTE: This fixture is not dimmable, so it
is best to not wire to a dimming switch.