Installation Guide

7
PROBRITE.COM
Please call 1-844-507-5651 or email [e-mail] for further assistance.
6
Visit www.probrite.com/install for installation video tutorials and product support
Installation (continued)
3
Remove the
mounting plate
B
CC
C
NOTE: The mounting plate (C) comes pre-as-
sembled on the light fixture (A) for shipping.
NOTE: The mounting plate tightening bolt
(B) comes pre-installed on the light fixture.
4
Installing the
mounting plate
AA
AA
C
C
Installation (continued)
5
Hang fixture to
mounting plate
6
Making the electrical
connections
TIP: Ensure the light fixture (A) can safely hang
onto the mounting plate (D) to allow for use of
two hands to make the wiring connections.
C
C
A
A
D
D
BB
BB
TIP: Only unscrew the tightening bolt (B) far
enough to remove the mounting plate (C).
Do not fully remove the tightening bolt (B).
LIGHTING
FIXTURE
(+) LINE
(-) COMMON
GROUND
BLACK
WHITE
GREEN
TIP: Hold stripped ends near each other and
align any frayed strands (do not twist wires).
Push the wires into wire nut (BB) and use your
fingers to twist the wire nut clockwise until tight.
Check for tightness by pulling wires.
☐ Route the junction box wires through
the large center hole in the mounting
plate (C).
☐ Align the holes on the mounting
bracket (C) with the holes on your
junction box. Use two #8 screws
(AA), depending on the size of the
holes in your junction box, attach
the mounting bracket (C) to your
junction box.
☐ Place the small sphere head of the
hanger wire (D) between the back of
the small grove located on the bottom
of the center hole of the mounting
plate (C).
Wall Mount
Ceiling Mount
Ceiling
Junction Box
A
D
C
Wall Mount
A
D
C
Ceiling Mount
(fig 1).
Wall Mount
Ceiling Mount
☐ Remove the mounting plate (C) from
the back of the fixture by loosening
the mounting plate tightening bolt (B)
using the allen key (CC).
☐ If necessary, strip 3/8" of insulation
from junction box or fixture (A) wires
(fig 1).
☐ Connect fixture black wire to house
black wire, the (+) line, and fixture
white wire to house white wire, the
(-) common by twisting the exposed
wires together and using the wire
nuts (BB). Ensure no loose wires.
☐ Connect house ground wire to the
green fixture ground wire, which
is attached to the mounting plate
(C), by twisting the exposed wires
together and using the wire nuts
(BB).