Installation Guide

ManualsBrandsPROBRITE ManualsLightingCommercial-Grade 650-Watt Equivalent Integrated Outdoor LED Wall Pack, 10000 Lumens, Dusk to Dawn Outdoor Security Light

MOUNTING INSTRUCTIONS:

JUNCTION BOX MOUNTING:

1. Unscrew 4 screws to open back box (Fig. 1)

2. Knock-out desired J-box mounting hole locations

3. Thread wire through hole in back housing and make wire

connections in j-box

4. Place gasket between back housing and J-box then fasten

securely to J-box

5. Re-attach xture to back housing

SURFACE MOUNTING:

1. Unscrew 4 screws to open back box (Fig. 1)

2. Knock-out desired mounting hole locations

3. Place gasket between wall and back housing and then secure

housing to wall

4. Remove plug from desired conduit entry location and attach

conduit, then make wiring connections

5. Re-attach xture to housing

AIMING:

Loosen hex bolt to aim head to desired location, then fasten

bolt securely.

WALL PACK LIGHT

26W

15.00’’ x 8.45’’ x 11.65’’

FIGURE 1

FIGURE 2

SUITABLE FOR WATTAGES:

MOUNTING INSTRUCTIONS

CAUTION: For proper weatherproof function all gaskets must be seated properly and all screws inserted and tightened rmly. Apply

weatherproof silicone sealant (NOT included) around the edge of the Wall Box and/or Junction Box. This is especially important with an

uneven wall surface. Silicone all plugs and unused conduit entries.

IMPORTANT: READ BEFORE REMOVING FIXTURE FROM CARTON. RETAIN FOR FUTURE REFERENCE.

This xture must be wired and installed in accordance with the NATIONAL ELECTRICAL CODE and all state and applicable local codes

and ordinances. These codes and ordinances supersede any and all instruction contained herein. Installation should be performed only by

a licensed and bonded electrician and a person familiar with the construction and operation of the product and the hazards involved in the

installation and operation of this product. Proper grounding is required for safety. Make certain power is OFF before installing or maintaining

xture. Failure to do so may increase the RISK OF PERSONAL INJURY, PROPERTY DAMAGE, FIRE, AND DEATH. The manufacturer takes

no responsibility for the product not installed under those guidelines and those contained in this document. See wiring diagram on back.

8.45 in

215 mm

11.65 in

296 mm

2.85 in

72 mm

8.45 in

215 mm

15.00 in

380 mm

4.25 in

108 mm

VER08.16

FIXTURE IS SUITABLE FOR WET LOCATION

Summary of content (2 pages)

PAGE 1
MOUNTING INSTRUCTIONS WALL PACK LIGHT SUITABLE FOR WATTAGES: 26W 4.25 in 108 mm 2.85 in 72 mm 8.45 in 215 mm 8.45 in 215 mm 11.65 in 296 mm 15.00 in 380 mm 15.00’’ x 8.45’’ x 11.65’’ IMPORTANT: READ BEFORE REMOVING FIXTURE FROM CARTON. RETAIN FOR FUTURE REFERENCE. This fixture must be wired and installed in accordance with the NATIONAL ELECTRICAL CODE and all state and applicable local codes and ordinances. These codes and ordinances supersede any and all instruction contained herein.
PAGE 2
MOUNTING INSTRUCTIONS WALL PACK LIGHT SUITABLE FOR WATTAGES: 26W (+) LINE BLACK (-) COMMON WHITE GROUND GROUND LIGHTING FIXTURE 3. Connect the black fixture lead to the (+) LINE supply lead (+) LINE BLACK (-) COMMON WHITE (+)DIM V+ PURPLE (-)DIM V- GRAY FIGURE 2 1. Connect the GROUND wire from fixture to supply ground 2.