Installation Guide

5
PROBRITE.COM
Please call 1-844-507-5651 or email [e-mail] for further assistance.
4
Visit www.probrite.com/install for installation video tutorials and product support
Pre-Installation (continued)
HARDWARE KIT
NOTE: Hardware not shown to actual size.
AA
BB
CC
DD
Part Description Quantity
AA
#8-32 x 3/4" philips mounting bracket screw 2
BB
Wire nut 3
CC
Clear photocell (light sensor) screw-on cap 1
DD
Allen key 1
PACKAGE CONTENTS
Part Description Quantity
A
Light fixture 1
B
Photocell (light sensor) 1
C
Mounting plate tightening bolt (pre-installed) 1
D
Mounting plate with gasket (pre-installed) 1
E
Hanger Wire for hands-free installation (pre-installed) 1
F
Opaque photocell (light sensor) screw-on cap 1
Installation
1
For best results
Wall Mount
1-1/2" 1-1/2"
Round Octagonal
A
B
F
C
E
D
NOTE: Mounting plate (D) mounts to
recessed mounted standard junction boxes.
Junction box must be at least 1-1/2 inch in
depth for proper installation for recessed
mount application (fig 2).
(fig 1).
(fig 2).
2
Shut electric power off
☐ At wall switch verify it is in the o
position (fig 1).
☐ At the main electrical panel turn o
the circuit breaker that supplies power
to the outlet box you are working on
(fig 2).
☐ For screw-in type fuses unscrew the
fuse that supplies power to the outlet
box you are working on (fig 3).
(fig 1).
(fig 2).
(fig 3).
☐ Install light 5-10 feet above the ground.
☐ Do not mount fixture close to reflective
surfaces such as windows, white walls,
white surfaces and water.
☐ When installing two fixtures on one
switch, make sure the switch is rated
for at least a 1A inductive load.
☐ Do NOT wire to a dimming switch.
☐ When mounting fixture, make sure the
photocell orientation is at the top.
☐ When mounting, make sure the fixture
is 7 in. on center away from eave and
13 inches on center away from inside
corner of the exterior wall (fig 1).