Installation Guide

9
PROBRITE.COM
Please call 1-844-507-5651 or email [e-mail] for further assistance.
8
Visit www.probrite.com/install for installation video tutorials and product support
C
DD
A
B
Installation (continued)
7
Mounting the light
fixture
☐ Once the fixture is wired, place the light
fixture (A) onto the mounting plate (D)
so the top sloped grove on the plate
rests on the top sloped grove on the
back of the fixture.
☐ Verify the fixture is flush with the wall
and photocell (B) is pointed downward
for wall mount or away from building on
eave mount.
☐ Tighten the mounting plate tightening
bolt (C) back through the hole on the
bottom of the fixture (A) until the bolt
firmly pushes against the mounting
plate (D).
8
Caulking around the
light fixture
☐ Caulk around the mounting plate (D)
and surface with silicone sealant (not
included).
9
Adjusting the light
heads and testing
☐ After fixture is securely mounted, use your
hand to pan and tilt each individual light
head on the fixture (A) to point towards
the direction desired.
☐ If one or both heads on the fixture (A)
appear loose, use a philips screwdriver to
tighten the screws located on the arms of
the light heads.
☐ From the breaker and switch, turn power
back ON to the light fixture to check if it
lights up. Make sure the photocell (B) has
no light entering it when testing.
D
NOTICE: Failure to properly caulk around the
surface and mounting plate (D) could lead
to water damage and is not covered under
warranty.
NOTE: When attaching this fixture (A) to an
external, surface mount junction box, caulk the
inside of the light fixture before attaching to the
mounting plate (D).
A
WARNING: Risk of fire. Keep the lamp heads
at least 3 in. (76mm) from combustible
materials.
CAUTION: Keep lamp heads 30° below
horizontal to prevent water damage and
electrical shock.
Operation
1
Selecting Dusk-to-Dawn or
Switch-Activated control
OPTION 1: DUSK-TO-DAWN OPERATION
Dusk-to-dawn operation enables the light fixture to automatically turn
ON when dark outside and turn OFF when the sun rises, thus saving you
energy.
☐ To enable dusk-to-dawn operation
remove black cap cover and ensure the
photocell (B) has clear cap cover on it
and is unobstructed.
☐ Ensure the switch powering the outlet
connected to the light fixture is turned
to the ON position and leave it ON at all
times to enable dusk-to-dawn function-
ality to operate automatically.
NOTE: If photocell (B) is located in an area
under heavy shade the photocell may not
detect enough light and may turn the light
fixture on.
TIP: To test if the light fixture (A) and pho-
tocell (B) works properly run power to the
fixture and cover the photocell to turn fixture
ON. Shine a light into the photocell to see if
fixture turns OFF.
OPTION 2: SWITCH CONTROLLED
Switch controlled operation enables the light fixture to turn ON and
OFF by flipping a switch that controls the electricity to the outlet
powering the fixture. The light fixture will not turn ON and OFF
automatically, but is manually controlled.
A
B
(Leave the black cap cover over the
photocell)
☐ To enable switch activated operation
leave the black screw-on cap the
photocell (already installed on the
fixture) and remove the instructions
label.
A
B
(Clear cap cover on photocell for
Dusk-to-Dawn Operation)
AUTOMATIC
NIGHTTIME ON
DAYTIME OFF
SWITCH
CONTROLLED