Installation Guide

9
PROBRITE.COM
Please call 1-844-507-5651 or email [e-mail] for further assistance.
8
Visit www.probrite.com/install for installation video tutorials and product support
C
D
CC
A
B
Installation (continued) Operation (continued)
7
Mounting the light
fixture
☐ Once the fixture is wired, place the light
fixture (A) onto the mounting plate (D)
so the top sloped grove on the plate
rests on the top sloped grove on the
back of the fixture.
☐ Verify the fixture is flush with the wall
and photocell (B) is pointed upward for
wall mount.
☐ Tighten the mounting plate tightening
bolt (C) back through the hole on the
bottom of the fixture (A) until the bolt
firmly pushes against the mounting
plate (D).
8
Caulking around the
light fixture
☐ Caulk around the mounting plate (D)
and surface with silicone sealant (not
included).
D
NOTICE: Failure to properly caulk around the
surface and mounting plate (D) could lead
to water damage and is not covered under
warranty.
NOTE: When attaching this fixture (A) to an
external, surface mount junction box, caulk the
inside of the light fixture before attaching to the
mounting plate (D).
☐ To enable dusk-to-dawn operation
remove temporary black label cover and
ensure the photocell (B) has no cover
on it and is unobstructed.
☐ Ensure the switch powering the outlet
connected to the light fixture is turned
to the ON position and leave it ON
at all times to enable dusk-to-dawn
functionality to operate automatically.
NOTE: If photocell (B) is located in an area
under heavy shade the photocell may not
detect enough light and may turn the light
fixture on.
TIP: To test if the light fixture (A) and pho-
tocell (B) works properly run power to the
fixture and cover the photocell to turn fixture
ON. Shine a light into the photocell to see if
fixture turns OFF.
OPTION 2: SWITCH-CONTROLLED
Switch controlled operation enables the light fixture to
turn ON and OFF by flipping a switch that controls the
electricity to the outlet powering the fixture. The light
fixture will not turn ON and OFF automatically, but is
manually controlled.
(Paste the black label cover provided in
the kit)
☐ To enable switch activated operation
paste the black cover sticker (DD),
provided in the hardware kit, on the
photocell (B).
A
B
(No cover on photocell for Dusk-to-
Dawn Operation)
Operation
1
Selecting Dusk-to-Dawn or
Switch-Activated control
OPTION 1: DUSK-TO-DAWN OPERATION
Dusk-to-dawn operation enables the light fixture to automatically turn
ON when dark outside and turn OFF when the sun rises, thus saving you
energy.
A
B
DD
Care and Cleaning
☐ Shut o main power supply before cleaning the product. To prolong the original
appearance, clean the light fixture with clear water and a soft, damp cloth only.
☐ Do not use abrasive cleaners or cleaners that contain alcohol. Do not apply paints,
solvents, or any other chemicals on this light fixture. They could cause a premature
deterioration of the finish and may void the warranty.
☐ Do not spray the light fixture with a hose or power washer.
AUTOMATIC
NIGHTTIME ON
DAYTIME OFF
SWITCH
CONTROLLED