Installation Guide

5
PROBRITE.COM
Please call 1-844-507-5651 or email [e-mail] for further assistance.
4
Visit www.probrite.com/install for installation video tutorials and product support
Pre-Installation (continued)
HARDWARE KIT
NOTE: Hardware not shown to actual size.
AA
BB
CC
DD
Part Description Quantity
AA #8-32 x 3/4" philips mounting bracket screw 2
BB Wire nut 3
CC Allen key 1
DD Photocell Black Cover Label 1
PACKAGE CONTENTS
Part Description Quantity
A Light fixture 1
B Photocell (light sensor) 1
C Mounting plate tightening bolt (pre-installed) 1
D Mounting plate with gasket (pre-installed) 1
E Hanger Wire for hands-free installation (pre-installed) 1
Installation
1
For best results
Wall Mount
1-1/2" 1-1/2"
Round Octagonal
A
B
C
E
D
NOTE: Mounting plate (D) mounts to recessed
mounted standard junction boxes. Junction box
must be at least 1-1/2 inch in depth for proper
installation for recessed mount application
(fig 2).
(fig 1).
(fig 2).
2
Shut electric power o
☐ At wall switch verify it is in the o position
(fig 1).
☐ At the main electrical panel turn o the
circuit breaker that supplies power to the
outlet box you are working on (fig 2).
☐ For screw-in type fuses unscrew the fuse
that supplies power to the outlet box you
are working on (fig 3).
(fig 1).
(fig 2).
(fig 3).
☐ Install light 5-15 feet above the ground.
☐ Do not mount fixture close to reflective
surfaces such as windows, white walls,
white surfaces and water.
☐ When installing two fixtures on one
switch, make sure the switch is rated for
at least a 1A inductive load.
☐ Do NOT wire to dimming switch.
☐ When mounting fixture, make sure the
photocell orientation is at the top for
wall mount.
☐ When mounting to a wall, make sure
the fixture is 7 in. on center away from
eave and 13 inches on center away from
inside corner of the exterior wall (fig 1).
PHOTOCELL COVER