Installation Guide

5
PROBRITE.COM
Please call 1-844-507-5651 or email [e-mail] for further assistance.
4
Visit www.probrite.com/install for installation video tutorials and product support
Pre-Installation (continued)
HARDWARE KIT
NOTE: Hardware not shown to actual size.
AA
BB
CC
DD
EE FF
Part Description Quantity
AA
Hex Head Lag bolts 3
BB
Wire nut 3
CC
Flat Washers 3
DD
Photocell black cover label 1
EE
Mounting bracket 1
FF
Rubber grommet 1
PACKAGE CONTENTS
Part Description Quantity
A
Light fixture 1
B
120-277V NEMA Twist-lock 3-Pin Photocell
(provided separately in the box)
1
C
Wire cover plate 1
D
Fixture arm 1
Installation
1
For best results
Wall Mount
Extension Arm Mount
A
B
C
D
(fig 1).
2
Shut electric power off
☐ At wall switch verify it is in the o
position (fig 1).
☐ At the main electrical panel turn o the
circuit breaker that supplies power to the
outlet box you are working on (fig 2).
☐ For screw-in type fuses unscrew the fuse
that supplies power to the outlet box you
are working on (fig 3).
(fig 1).
(fig 2).
(fig 3).
☐ Install light 12-30 feet above the ground.
☐ Place the photocell (provided separately
in the box) on the receptor on top of the
fixture and rotate in the direction of the
arrow marked on the photocell.
☐ When mounting fixture, for Dusk to Dawn
operation, make sure the photocell is in
an area that receives daylight and not too
close to reflective surfaces.
☐ When installing two fixtures on one
switch, make sure the switch is rated for
at least a 1A inductive load.
☐ Do NOT wire to dimming switch.
☐ When mounting to a wall, make sure the
fixture is 7 in. on center away from eave
and 13 inches on center away from inside
CAUTION: Do not try to rotate the photocell
receptacle on top of the fixture as it may twist
the wiring.
NOTE: Make sure the photocell is locked on
the receptor. Do not over rotate after it is
locked.