Installation Guide

5
PROBRITE.COM
Please call 1-844-507-5651 or email [e-mail] for further assistance.
4
Visit www.probrite.com/install for installation video tutorials and product support
Pre-Installation (continued)
HARDWARE KIT
NOTE: Hardware not shown to actual size.
AA
BB
CC
DD
EE FF
Part Description Quantity
AA
Hex Head Lag bolts 3
BB
Wire nut 3
CC
Flat washers 3
DD
Photocell opaque black cap cover 1
EE
Extension pole arm mounting bracket 1
FF
Rubber grommet 1
PACKAGE CONTENTS
Part Description Quantity
A
Light fixture 1
B
Photocell (light sensor) 1
C
Wire cover plate 1
D
Fixture arm 1
Installation
1
For best results
Wall Mount
Extension Arm Mount
(fig 1).
2
Shut electric power off
☐ At wall switch verify it is in the o
position (fig 1).
☐ At the main electrical panel turn o
the circuit breaker that supplies power
to the outlet box you are working on
(fig 2).
☐ For screw-in type fuses unscrew the
fuse that supplies power to the outlet
box you are working on (fig 3).
(fig 1).
(fig 2).
(fig 3).
☐ Install light 8-15 feet above the ground.
☐ When mounting fixture, for Dusk
to Dawn operation, make sure the
photocell is in an area that receives
daylight and not too close to reflective
surfaces.
☐ When installing two fixtures on one
switch, make sure the switch is rated
for at least a 1A inductive load.
☐ Do NOT wire to dimming switch.
☐ When mounting to a wall, make sure
the fixture is 7 in. on center away from
eave and 13 inches on center away
from inside corner of the exterior wall
(fig 1).
A
B
C
D
20W