Installation Guide

5
PROBRITE.COM
Please call 1-844-507-5651 or email [e-mail] for further assistance.
4
Visit www.probrite.com/install for installation video tutorials and product support
Pre-Installation (continued)
HARDWARE KIT
NOTE: Hardware not shown to actual size.
AA
BB
CC
DD
Part Description Quantity
AA
#8-32 x 3/4" philips mounting bracket screw 2
BB
Wire nut 3
CC
Photocell (light sensor) screw-on clear cap 1
DD
Allen key 1
PACKAGE CONTENTS
Part Description Quantity
A
Light fixture 1
B
Photocell (light sensor) 1
C
Mounting plate tightening bolt (pre-installed) 2
D
Mounting plate (pre-installed) 1
E
Photocell (light sensor) screw-on opaque cap 1
Installation
1
For best results
Wall Mount
1-1/2" 1-1/2"
Round Octagonal/
A
B
C
D
NOTE: Mounting plate (D) mounts to
recessed mounted standard junction boxes.
Junction box must be at least 1-1/2 inch in
depth for proper installation for recessed
mount application (fig 1).
(fig 1).
2
Shut electric power off
☐ At wall switch verify it is in the o
position (fig 1).
☐ At the main electrical panel turn o the
circuit breaker that supplies power to
the outlet box you are working on (fig
2).
☐ For screw-in type fuses unscrew the
fuse that supplies power to the outlet
box you are working on (fig 3).
(fig 1).
(fig 2).
(fig 3).
☐ Install light 8-18 feet above the ground.
☐ When mounting fixture, for Dusk to
Dawn operation, make sure the photocell
orientation is at the top for wall mount,
in an area that receives daylight and not
too close to reflective surfaces.
☐ When installing two fixtures on one
switch, make sure the switch is rated for
at least a 1A inductive load.
☐ The fixture may or may not be wired to a
0-10V dimming switch.
E