® WidowMaker 22 Brushless Electric Powered Deep-V Owners Manual Specifications Hull Length..................................................................................... 22 in (558mm) Beam............................................................................................ 6.5 in (165mm) Motor.............................................................. Water-cooled Hi-performance 2900Kv Radio System............................................................
Introduction The WidowMaker 22 Brushless EP comes Ready-To-Run with the Pro Boat 27MHz AM radio system and electronic speed controller already installed. All assembly and building is done at the factory, allowing you to quickly get your boat running. Thank you for purchasing the Pro Boat® WidowMaker 22 Brushless EP Ready-To-Run boat. Please read these instructions carefully before attempting to operate your boat. Table of Contents Introduction...............................................................
General Guidelines It is important that you read and follow this instruction manual, along with the radio system manual before you run this exciting boat. Failure to read and understand the manual could result in personal injury, property damage or permanent damage to your boat. It is also important to run your boat responsibly. With proper care and maintenance, you will be able to proudly enjoy your WidowMaker 22 Brushless Deep-V for many years to come.
Contents • Assembled WidowMaker 22 Brushless EP RTR • Pro Boat radio transmitter • Boat stand Section 1: Assembling the Boat Stand Attach the side stand pieces by interlocking them into the end pieces as shown. Secure the interlocking pieces with medium CA or epoxy. Make certain you allow the adhesive to fully cure before placing your boat on the stand.
Section 3: Installing the Battery Pack Follow the instructions included with your fast charger to ensure a safe charge. Carefully remove the hatch from the hull. Attach the hook and loop material to the batteries and the battery boxes. The Pro Boat water-cooled ESC comes pre-wired with a Deans connector. Use a 6-cell battery pack listed below for optimum performance. Install a fully charged battery pack into the hull. • PRB3313 7 .2V 3600mAh w/Deans Connector • PRB3314 7 .
Section 4: Adjusting the Transmitter Note: Refer to the radio instructions for specific information on transmitter setup. Adjust the rudder trim knob so that the rudder is centered prior to operation. You may adjust this control to make the boat run straight during operation. Adjust both the Throttle and Steering trims to the center position. Turn on the transmitter, then connect the battery to the ESC.
Section 5: Checking the Radio System The control arm should move toward the back of the boat when right input is given. Conversely, when left input is given, the control arm should move toward the front of the boat. The ESC will beep until you give full throttle input. The auto sensing circuitry will select full throttle position when you hold full throttle during initial setup. Release the throttle trigger.
Section 6: Testing Your Boat in the Water Make sure the radio is "ON" and the batteries are plugged into the speed controller. Test the radio system for proper operation and then carefully place the boat in the water. Pilot the boat at slow speeds, staying close to the shoreline to ensure you have good control and that the boat is functioning correctly. Be certain to avoid all objects in the water at all times.
Section 8: Maintenance Before and at the end of each run, make sure all screws are tight and the propeller is free from any entanglement. Section 9: Speed Control Programming Note: Do not turn off the transmitter first or the receiver may pick up stray signals and run out of control. The electronic speed control (esc) features a Ni-MH/Li-Po switch to easily change the cutoff voltage for each battery type.
Section 10: Lubricating the Drive Shaft 2. Remove the 3mm propeller strut screw and remove the drive system by sliding the flex shaft out of the stuffing box. 3mm propeller strut screw Leave a 1mm–2mm gap here to allow for flex shaft shrinkage under load. Note: Running the WidowMaker 22 Brushless EP RTR in salt water could cause some parts to corrode. If you run the boat in salt water, rinse it thoroughly in fresh water after each use and lubricate the drive system. 3.
Section 11: Warranty Information Age Recommendation Damage Limits Age Recommendation: 14 years or over. This is not a toy. This product is not intended for use by children without direct adult supervision. HORIZON SHALL NOT BE LIABLE FOR SPECIAL, INDIRECT OR CONSEQUENTIAL DAMAGES, LOSS OF PROFITS OR PRODUCTION OR COMMERCIAL LOSS IN ANY WAY CONNECTED WITH THE PRODUCT, WHETHER SUCH CLAIM IS BASED IN CONTRACT, WARRANTY, NEGLIGENCE, OR STRICT LIABILITY.
Section 11: Warranty Information Inspection or Repairs United States: Electronics and engines requiring inspection or repair should be shipped to the following address: If this Product needs to be inspected or repaired, please call for a Return Merchandise Authorization (RMA). Pack the Product securely using a shipping carton. Please note that original boxes may be included, but are not designed to withstand the rigors of shipping without additional protection.
Section 11: Warranty Information FCC Information Declaration of Conformity This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Section 12: Replacement Parts If you have any questions concerning the setup or running of your WidowMaker 22 Brushless EP boat, please call the Horizon Service Center toll-free at (877) 504-0233. PRB0150 PRB2068 PRB2218 PRB2219 PRB2223 PRB2224 PRB2226 PRB2228 PRB2811 PRB2813 PRB3307 PRB3308 PRB3312 PRB3313 PRB3314 PRB3901 1.34" x 2.
Operating Notes 15
® © 2009, Horizon Hobby, Inc. 4105 Fieldstone Road Champaign, Illinois 61822 (877) 504-0233 www.horizonhobby.
