Specifications

Problem Solution

Engine will not start Engine is not primed: Put a few drops of fuel into

the carburetor venturi and restart

Out of fuel: fill fuel tank

Improper fuel: use 20% Blue Thunder™

Improper glow plug: install proper glow plug

Glow igniter not charged: charge igniter

Dead glow plug: replace

Flooded engine: remove glow plug, invert boat and

engage the Tiger Drive to remove raw fuel from the

engine

Engine starts, then dies Pressure line blocked or unhooked: connect or

replace fuel line

Reset needles to baseline setting: see Section 9

Engine starts and runs for several minutes, then dies Bad glow plug: replace

Idle speed set too low: see Section 9

Improper needle settings: see Section 9

Glow plug failed due to lean engine setting: richen

carburetor settings and replace glow plug

Section 10: Troubleshooting Guide