User Manual

3
 Install 12 volt AC adapter (4 pin XLR) in the
socket of Joysck Box.
NOTE: Any 12 volt baery may operate this
Pan Tilt Head as long as the Connector and the
#1 Negave pin & #4 Posive pin of Cable meet
together.
CAUTION: Do not use an unregulated power supply! If using a regulated power supply, it must produce
less than 12 volts. More than 24 volts may cause permanent damage.
 Aach 4-pin Power Cable with Joysck
Controller. Then aach other cables of the
motors with long cable.
 Aach the 4-pin male connector of Cable to
4-pin female connector of Head for Panning &
Tilng.
 Aach & secure your camera on camera
plaorm of Head with the help of provided
chucknut.
NOTE: If the Joysck Control is opposite, undo
the connectors of motors, rotate 180° and
re-install.
The Joysck is a 2-Axis Variable Speed Servo Controller. The further you move in one direcon, the faster
the output to that motor. This will be a lile tricky at rst, but lile pracce will improve your success.
The joysck may be operated in a handheld posion or from a at surface such as a tabletop, or aached
to the boom arm of Jib.
NOTE: Aer plugging the power cord into a proper outlet, press ‘Power On’. The LED light on the control
box should illuminate and the head may jump slightly on start up or shut down. This is normal. This can be
controlled by Dead Spot. Adjust the Joysck to ensure correct movement of head. It may be necessary to
reconnect to the motors, if required.
Speed
This is the power control knob. Turning to the right will be full power and back to the le will decrease
the available power to both pan and lt operaon. The advantage of power control is to be able to limit
power when only slow accurate movements are needed. With the power control at half power (approx. 8
volts max. output) the full range of moon on the joysck will be between 0 and 8 volts making ner
adjustments possible. The power control will be usable between approximately 4 volts to 12 volts.
Funconing of Joysck Controller