User Manual

ManualsBrandsPROAIM ManualsCamera & PhotoProfessional Motorized Sr. Pan Tilt Head with 12V Joystick Control for DSLR Video Cameras Camcorders up to 7.5kg/16.5lbs for Jib Crane Tripod + Carrying Bag

What’s In The Box

Please inspect the contents of your shipped package to ensure you have received everything that

is listed below.

No part of this document may be reproduced, stored in a retrieval system, or transmied by any form or by any means,

electronic, mechanical, photo-copying, recording, or otherwise, except as may be expressly permied by the applicable copyright

statutes or in wring by the Publisher.

Sr. Pan-Tilt Head

Ass e mb l y M a n u a l

with 12V Joysck Control (PT-SR)

Sr. Pan-Tilt Head

12V Joysck Controller

Safety cap

3 mtr Cable

15 mtr Cable

12V AC Adapter

Universal Adapter

Fasteners

Storage Bag

Summary of content (5 pages)

PAGE 1
Sr. Pan-Tilt Head with 12V Joystick Control (PT-SR) Assembly Manual What’s In The Box Please inspect the contents of your shipped package to ensure you have received everything that is listed below. 12V Joystick Controller Safety cap 3 mtr Cable 15 mtr Cable 12V AC Adapter Universal Adapter Fasteners Storage Bag Sr. Pan-Tilt Head All rights reserved.
PAGE 2
Parts of Pan-Tilt Head 1 16 15 17 9 4 5 10 8 11 12 2 13 3 14 6 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. Gear for Tilting Movement Gear for Panning Movement 12V Motor for Panning Movement 12V Motor for Tilting Movement Adjustable Camera Platform Base Platform for Tripod/Jib Mounting Joystick for Pan/Tilt Movement On/Off Switch Pan Speed Tilt Speed 7 11. 12. 13. 14. 15. 16. 17.
PAGE 3
 Install 12 volt AC adapter (4 pin XLR) in the socket of Joystick Box. NOTE: Any 12 volt battery may operate this Pan Tilt Head as long as the Connector and the #1 Negative pin & #4 Positive pin of Cable meet together. CAUTION: Do not use an unregulated power supply! If using a regulated power supply, it must produce less than 12 volts. More than 24 volts may cause permanent damage.  Attach 4-pin Power Cable with Joystick Controller. Then attach other cables of the motors with long cable.
PAGE 4
Linear or Logarithmic Taper Joystick Control All joysticks are linear, meaning that each degree of movement of the stick correlates to the output. On the 12 volt Pan Tilt Head, half deflection of joystick means approximately 6 volts is sent to the motors. But with the advent of Digital, we can now control the taper of joystick, making in Logarithmic as well.
PAGE 5
 Gently tighten motor screws.  Secure the camera. NOTE: All reduction boxes have a small amount of backlash. The balancing of the camera will reduce the backlash to a minimum making it felt at the top of the tilt arc. Operation  With the camera set up, as previously described above, switch ON the power on Joystick Controller.  For inverted use, disconnect the leads to the motors, rotate the control box 180° and re-install. NOTE: Always watch the cables for binding. YOUR PROAIM SR.