User Guide

Proaim Sr. Pan-Tilt Head with 12V Joysck Control 5
BALANCING
Follow these steps to balance the head :-
 Find the horizontal balance point of your camera by using 2 ngers of one hand while holding
the handle.
 Mark this point on the side of the camera with chalk or tape.
 Turn the unit on and move the lt control unl the camera plate is vercal.
 Loosen the two screws holding lt motor. (DO NOT REMOVE).
 Grasp the motor and turn slightly to disengage gears.
 Mount the camera to the camera plate with the screw provided.
 Tighten by threading the nut up to the boom of the camera plate securely.
 Make sure your balance point previously marked with chalk or tape is in the middle of the plate.
 Loosen the knob below the camera plate and slide the camera and plate up or down unl the
center line of your camera is about in the middle of the large gear. Now ghten knob.
 If the camera is perfectly balanced it will stay in any posion while motor gear is sll
unaached.
 Grasp the motor and turn it back unl the gears mesh.
 Gently ghten motor screws
 Secure the camera.
 Aach & secure your camera on the camera
plaorm of Head with the help of provided
chuck nut.
OPERATION
 With the camera set up as previously described above, Power ON by pressing the RED Switch on
the top of the Joysck control box.
 For inverted use, disconnect the leads to the motors, rotate the control box 180 degrees and re-
install.
Note: All boxes have a small amount of backlash. The balancing of the camera will reduce the backlash
to a minimum making it felt at the top of the lt arc.
Note : Always watch the cables for binding.