Pro1 Operation Manual

Thermostat OperationThermostat Operation
Glow in the dark light button
Fan Switch
System Switch
Temperature Setpoint Buttons
LCD Display
User Buttons
LCD Display
Glow in the dark light button
Fan Switch
System Switch
See page 4 for details about
this display read out.
The glow in the dark light
button will self illuminate
for several hours after
exposure to ambient light.
This button turns on the
display light when pressed.
Select ON or AUTO. ON will
run the fan continuously.
AUTO will cycle the fan on
only when the heating or
cooling system is on.
Selects the operation mode
on your HVAC system.
Selecting HEAT turns on
the heat mode. Selecting
COOL turns on the air
conditioning mode.
Selecting OFF turns both
heating and cooling o.
When the battery icon appears replace your AA
batteries immediately. Failure to do so may result in your
heating & cooling system becoming inoperable. Freezing or
over heating can occur.
Caution:
LOW
User Buttons
Use these buttons to set up
your programming options.
Refer to the next page for
detail.
Temperature Setpoint Buttons
Press the + or - buttons to
select the desired room
temperature.
ON AUTO COOL OFF HEAT