Install Instructions

ManualsBrandsPRO1 IAQ ManualsBuilding SuppliesPRO1 IAQ T701 Non-Programmable Electronic Thermostat

Una versión española de este

manual puede ser descargada

en www.pro1iaq.com

This manual covers the following models:

• T701

® U.S. Registered Trademark. Patents pending.

Mounting and Battery Installation

For assistance with this product please visit

http://www.pro1iaq.com or call Pro1

Customer Care toll-free at 888-Pro1iaq

(776-1427) during normal business hours

(Mon-Fri 9 AM - 6 PM Eastern)

Rev. 0850

Summary of content (10 pages)

PAGE 1
This manual covers the following models: • T701 Mounting and Battery Installation Una versión española de este manual puede ser descargada en www.pro1iaq.com ® U.S. Registered Trademark. Patents pending. Copyright © 2006 Pro1 IAQ, Inc. All rights reserved. For assistance with this product please visit http://www.pro1iaq.com or call Pro1 Customer Care toll-free at 888-Pro1iaq (776-1427) during normal business hours (Mon-Fri 9 AM - 6 PM Eastern) Rev.
PAGE 2
PAGE 3
Getting to know your thermostat 1 2 1 LCD Displays the user selectable setpoint temperature. 6 3 4 5 2 Glow in the Dark Light Button 3 Fan Switch 4 System Switch 5 Easy Change Battery Door 6 Temperature Setpoint Buttons Low Battery Indicator: Replace batteries when indicator is shown. System operation indicators: The COOL, HEAT or FAN icon will display when the COOL, HEAT or FAN is on. NOTE: The compressor delay feature is active if these icons are flashing.
PAGE 4
SUBBASE INSTALLATION
PAGE 5
PAGE 6
PAGE 7
Select ELEC or GAS with this switch Reset button Delay The compressor delay will not allow the compressor to be turned on for 5 minutes after the last time the compressor was on. The cooling icon will flash during the delay period. Select OFF or ON with the jumper pin as desired.
PAGE 8
Adjusting the Temperature Swing The swing setting, often called CYCLE RATE, DIFFERENTIAL or ANTICIPATION is adjustable. A smaller swing setting will cause more frequent cycles and a larger swing setting will cause fewer cycles. There are separate swing settings for heat and for cool. Follow the steps below to adjust the SWING setting for heat or cool: 1. Select HEAT or COOL with the system switch. and 2. Hold down the keys together for 3 seconds. or key to 3. Use the adjust the swing.
PAGE 9
subbase 9
PAGE 10
Pro1 IAQ Inc. 1111 S. Glenstone Suite 2-100 Springfield, MO 65804 Toll-free: 1-888-Pro1iaq (776-1427) Toll Number (Outside the USA): 330-821-3600 Web: http://www.pro1iaq.