Specifications

PRO WELD
CD-212 GAP
TABLE OF CONTENTS
1.0 INTRODUCTION 1
2.0 WARRANTY 1
3.0 UNPACKING YOUR UNIT 1
4.0 SUGGESTED SAFETY PRECAUTIONS 1
5.0 GENERA L DESCRIPTION 2
6.0 THE CD WELDING PROCESS 2
7.0 POWER REQUIREMENTS 3
8.0 SYSTEM SPECIFICATIONS 3
9.0 WELDING SYSTEM HOOK - UP 4
9.1 Straight Polarity 4
9.2 Reverse Polarity 5
10.0 SYSTEM OPERATION 6
11.0 GUN SET - UP 7
11.1 Standard 7
11.2 Installin g or Changing Collets or Chucks 8
11.3 For Weld Pins with Collet Protector 8
11.4 Template Adapter 9
11.5 Collet Protector wi th Blunt Leg 9
11.6 Parts List Gap Gun 10
11.7 Adjusting Gap Gun 11
11.8 Installation of Collet 12
11.9 Adjusting Spring Pre ssure 13
11.6 Parts List LD CD Handgun 15
12.0 WELDABLE MATERIAL COMBINATIONS 16
13.0 CAUSES OF POOR OR ERRATIC WELDS 13
14. 0 TROUBLE SHOOTING POOR WELDS 17
15.0 ROUTINE WELDER MAINTENANCE 18
16.0 ASSEMBLY – CD - 212 CONTROLLER 19.20
16.1 PC Board Asse mbly Drawing 21
17.0 TROUBLE SHOOTING – ELECTRICAL 22
18.0 CHECK LIST CD - 212 SYSTEM P.N. 100 - 0112 24
19.0 CHECK LIST CD - 212 S YSTEM P.N. 100 - 0113 24