Operation Manual

37
TILTING MECHANISM
For easy access to your boot, even if the bikes are mounted on the carrier, you
may use the tilting mechanism.
First you must release
the locking. Start with
loosening the rotary knob
on the right side. Loosen
it until you cannot loosen
it any further.
Subsequently, you pull
up the locking pin in the
middle of the carrier and
rotate it by a quarter
turn (so that it stays released).
With one hand, keep a firm grip on the U-frame or the bikes, so that the carrier
can not fall down in an uncontrolled movement. Pull the carrier carefully towards
you (towards you!). Attention: Do NOT use the light holder to do this!
Now you can carefully tilt the carrier.
To return the carrier you must raise it first and then slide it back into the guide
until it cannot go any further. Secure the locking pin and firmly tighten the rotary
knob.
Attention: The carrier may never be used without both
locking pins secured! Make sure that both locking pins are
secured before you start driving!
Locking pin
Rotary knob