Product Brochure

38
PROFESSIONAL-GRADE CONSTRUCTION FASTENERS
Bugle Head
A countersunk head with a flat top and a concave
under head bearing surface.
Trim Head
Small countersunk head allows for a clean finish.
Pan Framer Head
Slotted pan heads have a flat or gently rounded top
surface, cylindrical sides and a flat bearing surface.
Modified Truss Head
The low profile head gives your project a clean
appearance. Phillips drive.
Low Profile Truss
The low profile head gives your project a clean
appearance. Phillips drive.
Round Head
Rounded top with a flat bearing surface.
Flat Head
Countersunk head with a flat top surface and a
cone-shaped bearing surface.
Flat Head with Nibs
Countersunk head with a flat top surface and a
cone-shaped bearing surface. Nibs allow the head to
sit flush.
Hex Washer Head
Has an indented top surface, six flat sides with a
flat washer which projects beyond the sides and
provides a flat bearing surface.
Hex Washer Head with Neoprene Washer
Same properties as the Hex Washer Head with the
addition of a water tight Neoprene Washer.
Wafer Head
Countersunk head with a flat top surface and a
cone-shaped bearing surface.
Wafer Head with Nibs
Countersunk head with a flat top surface and a
cone-shaped bearing surface. Nibs allow the head to
sit flush.
Pancake Head
Reduced Phillips drive used to achieve a flush
finish on metal job applications.
Pan Head
Has a rounded top with a flat bearing surface
greater in area than a round head screw.
Pro-Twist
®
Fasteners head styles
Pro-Twist
®
Fasteners point styles
Sharp Point
Forming screw used in metal .015 to .050
thick. Pro-Twist™ are tested to pierce 20 gauge
steel or less.
Self Piercing Needle Point
Self-piercing needle point penetrates sheet
metal from .0209 to .0358.
Self-Drilling
Special designed point used to pre-drill and
tap a hole in a one step application. Used in
thicker gauge materials that would require a
pre-drilled hole.
Self-Drilling with Wings
Used for attaching 5/8” to 2-1/4” materials
to thick gauge steel. The wings eliminate the
need to pre-drill the attached material.
Pilot Point
Used for attaching 3/4” to 1-1/8” materials
to thin gauge steel. The leading blank shank
eliminates thread engagement which is the
primary cause of jacking.
T-17 Point
Used for penetrating harder woods, eliminates
splitting during installation. Can also be used
in Light-Gauge applications.
Type A - Sharp point normally found on sheet metal screws, considered a coarse thread.
Type AB - Sharp point found on sheet metal screws. This is a finer thread than Type A.