User Manual

NEVER LEAVE HEATER UNATTENDED
WHILE BURNING OR WHILE CONNECTED
TO A FUEL SOURCE
© 2017, Pinnacle Climate Technologies, Inc. Propane Tank Top Heater User’s Manual
®
Assembly
PT-47-TTC (Continued):
– To have all 3 burners face front, the plane
washer should be to the right side of tank collar
bracket. (See Figure 6)
– To have far left burner face back, the plane
washer should be to the left side of tank collar
bracket. (See Figure 6)
Figure 6
Connecting Heater to LP Cylinder:
Be sure to read and understand all of the Safety
Information in this manual before connecting
the heater to the LP cylinder. Installation must
conform to local codes and with the Standard
for the Storage and Handling of Liquefied
Petroleum Gasses and ANSI/NFPA 58.
Inspect the hose and regulator prior to each use
of the heater. If there is excessive abrasion or
wear, or if the hose is cut, replace it with the
proper assembly shown in the parts list prior to
using the heater.
Model PT-16-TTC:
1. Be sure that the control knob on the regulator
is in the “OFF” position.
2. Line up the threads on the fuel connector nut
with the threads on the LP cylinder valve. Turn
fuel connector nut COUNTERCLOCKWISE to
tighten. Fully tighten the nut, being careful not
to over tighten.
3. Slowly open the LP cylinder valve.
Models PT-32-TTC / PT-47-TTC:
1. Be sure that the control knob on the regulator
is in the “OFF” position.
2. Line up the slots in the tank collar bracket
with the tank collar ring and slide into place.
Be sure the mounting knob is to the outside,
and tighten.
3. Line up the threads on the fuel connector nut
with the threads on the LP cylinder valve. Turn
fuel connector nut COUNTERCLOCKWISE to
tighten. Fully tighten the nut, being careful not
to over tighten.
4. Slowly open the LP cylinder valve.
Check all connections for leaks using a 50/50
mixture of dish-soap and water. Any bubbles
that appear show a leak. Remove and
reconnect the Connector Nut to the valve.
DO NOT direct the heater
discharge towards any
propane cylinder located within 20 feet of
the heater.
WARNING
7