Manual

(IV) PRE-STARTING OPERATION

1: Connect intake pipe

Used conmlercially available bose, pipe joint and pipe

connecting hoop. The intake pipe must be continuous and

can not be folded exceed what' s needed, the pump does

best when it is not far from the water. The time that

the pump takes water is in direct proportion to the

length of the intake pipe. The filter which forms

complete set with the pump must be fixed on the end the

intake pipe as shown in the picture.

QBefore pumping water, the filter must be fired on the

end of the intake pipe. The filter can help remove the

mess which may result in blocking and can harm the

impeller.

Caution: Fix the pipe joint and pipe connecting hoop

well, in case it leaks air and lower the intake power.

If the intake pipe is uncrowned, it will do harm to the

function of the pump and it will weaken the taking water

ability of the pump.

out[et pipe__

pipe connecting hoop

2: Connect outlet pipe

[se conmlercially available bose, pipe _joint and pipe

connecting hoop. i short pipe of by diameter does best,

long pipe of small diameter add to flowing resistance

and reduce the output rate of the pump.