User Manual

PT-0721 User’s Manual
www.prokits.com.tw 6
the machine may be damaged.
To set the drill to the lowest available torque setting, twist the torque control knob until the small arrow on the
drill-housing points to the “1” stamped on the torque control knob. In this position the torque clutch will slip with
light drilling resistance. The higher the number the arrow points to on the torque control knob, the larger the
maximum torque that can be applied before the torque clutch will slip.
To set the machine to maximum available torque twist the torque control knob until the arrow points to the drill
symbol. In this position there is no slip in the torque clutch.
Select a lower torque for insertion/removal of screws to avoid damage to the work-piece (in particular wooden
work-pieces) or to the screw. For drilling select a higher torque setting. Do a test first on an item which is not
your final work-piece and adjust the desired torque accordingly before you start the actual work.
Maintenance and Clean
Attention! Always remove the battery before carrying out any work on the machine.
To clean, always use a dry or moist, but not wet, towel. Many cleaning agents contain chemical substances
which may cause damage to the plastic parts of the machine. Therefore do not use any strong or inflammable
cleaners such as petrol, paint thinner, turpentine or similar cleaning agents.
Always keep air ventilation holes free of dust deposits to prevent overheating.
Service
For more information on PT-0721A / PT-0721F and other products, please visit www.prokits.com.tw
PT-0721 User’s Manual
www.prokits.com.tw 7
Certificate Number: TW98/12323QA