User Manual

PT-0721 User’s Manual
www.prokits.com.tw 4
Technical Data
Model PT-0721A PT-0721F
Rated Voltage DC 7.2V DC 7.2V
No-load Speed two gear speed:160rpm~320rpm two gear speed:160rpm~320rpm
Torque Setting 15+1 Position 15+1 Position
Output torque 5 N.M (MAX) 5 N.M (MAX)
Drive (Collet) 1/4 quick release chuck 1/4 quick release chuck
Battery Li-ion 7.2V 1300mAh Li-ion 7.2V 1300mAh
Charging Time 3-5 hours 3-5 hours
Free running time
70min. (unload speed) 70min. (unload speed)
Size
160*170*50mm 160*170*50mm
Weight (include battery) 0.5kg 0.5kg
Adaptor
120V AC 60Hz 9.2V DC 400mA 230V AC 50Hz 9.2V DC 400mA
Protection Class II
Complied with EN60335-2-29
Indoor operation only
.Accessory
Screwdriver bits
4pcs
Bit size
PH1 ; PH2 ;SL 5 ;SL 6 mm (L : 50mm)
PT-0721 User’s Manual
www.prokits.com.tw 5
Product Features
Initial operation
Charging the Battery
The rechargeable battery must be charged before the first use. Only recharge the battery once it is has been
fully discharged, i.e. the performance clearly decreases. Otherwise the battery may not achieve its full capacity
at the subsequent charge.
Important! Only use the provided battery charger for charging the battery. First insert the plug into
charging socket. Charging starts automatically.
Remove the plug from the socket after about 5 hours.
Inserting Tool Bits
The cordless screwdriver has a keyless chuck so you do not need a key to lock the tool bit in place. Make sure
that the screw bit is not skew when it is inserted and the chuck tightened.
To remove the bits from tool, push the ring of the chuck, then pull out the bits.
Operating Trigger
Use the operating trigger to start the machine and keep holding it for continuous operation.
To switch the machine off, release the operating trigger
Forward and Reverse Switch
Important! The machine has to come to a complete stop before the forward and reverse switch can be used;
otherwise the machine may be damaged.
Use the forward and reverse switch to switch between clockwise (normal) and anticlockwise rotation or
vice-versa. With the forward and reverse switch in the central position the trigger switch is locked and cannot be
depressed. Put the forward and reverse switch in the central position before you put the machine down, to
avoid unintentional starting.
Torque adjustment
You can control the maximum torque applied to the drill bit with the torque control knob.
Attention! The torque control knob should only be operated when the machine is not running; otherwise
Operating
Trigger
Forward &
Reverse Switch
Two Speed
Control
Torque
Adjustmen
t
Charging
Socke
t