Product Manual

7 Slope Matching
Slope Matching Mode, Y axis manually adjusted, X axis auto
levels.
• Slope Matching is useful when the conventional rotor cap is installed and
the laser is used as a planar reference.
• Use the sights on top of the laser to align it with the slope direction axis.
• Press the power switch to turn the laser on.
• Press the “Man” button for about 1/2 second. The “Man Y” axis amber
LED flashes quickly, (indicating the Y axis is in manual mode). Both
“Auto Y” LED’s become inactive while the “Auto X” LED’s continue to
operate in automatic mode.
• Use the arrow up and down buttons to move the laser plane to the desired
slope in the Y axis. When facing the control panel, the Up button moves
the far plane down and the Down button moves the near plane down. The
X axis will continue to auto level.
• The slope axis is manually set and does not self level. It is good practice to
set reference benchmarks in both axes and check to make sure your setup
has not changed.
• Note: Any press of the “Man” or arrow buttons restarts the Height Alert.
• If a Y axis leveling limit is reached while manually setting slope, the red
LED in the “Man Y” axis window and the X axis red limit LED will flash.
The laser must be turned off to return to automatic mode.
• The green power LED and the laser beam will turn on once the X axis
reaches level.
• To exit this mode, press the “MAN” button (a deliberate ~1/2 second
press). The laser will switch to full automatic leveling mode. If the laser is
powered down, when it is restarted, it will always start in full automatic
leveling mode.