Product Manual

Case Contents (will vary depending on package ordered)
Battery Installation
Pull on tab at base of door to remove.
Install 4 C (alkaline or NiMH rechargeable) according to instructions molded
on battery holder. Carbon batteries are not recommended.
Replace battery door by hooking cover into slots at the top of the housing and
pressing the tab closed. Do not plug the charger into the laser unless NiMH
batteries are installed!
NiMH batteries should be fully charged (about 12 hours) prior to initial use.
Caution, charge NiMH rechargeable batteries only!
1
Getting Started
Instruction packet
Batteries
Receiver
Conventional
rotor cap