Item Brochure

Alpha
-
c Specifications
Contact Your Pro ShotTM Dealer Today:
LASER
REFERENCE
www
ww w
.
pro
pr o
shot
sh ot
laser
la ser
.
com
co m
• Easy to set your desired slope
• Easy to set your desired slope
• Wide range of slopes, either up or down.
• Wide range of slopes, either up or down.
• Servo leveling for one button start-up
• Servo leveling for one button start-up
• Built tough to survive real jobsite use
• Easy to set your desired slope
• Wide range of slopes, either up or down.
• Servo leveling for one button start-up
• Built tough to survive real jobsite use
The right tool for the job
151 Martinvale Lane • San Jose, CA 95119 • USA • Tel: [phone] • Fax: [phone]
151 Martinvale Lane • San Jose, CA 95119 • USA • Tel: [phone] • Fax: [phone]
Range with R7 laser receiver ....
Horizontal accuracy ..................
Cone slope capability ................
High resolution version..............
Leveling technology • Range ....
Height alert ................................
Slope matching • Range ...........
Rotation coverage • speed ........
Machine control compatible ......
Warranty.....................................
Power source • Life ...................
Rechargeable batts. • Life ......
Laser beam type ....................
Laser classification ...............
Dust and water sealed ........
Operating temperature ......
2000’ dia., 1000’ rad. (610m/305m)
± 10 arc sec. (±1/16" per 100')
(±1.5mm per 30m)
±4%, 1/4% increments
±1.7%, 1/10% increments
Servo motor self leveling • ±5º
Normally active, can be disabled
Single axis, X-axis self leveled • 8%
360º • 500rpm.
Yes, with most modern systems
24 Month defects coverage
Four C-cells • 75 hrs. (alkaline)
Optional Ni-Mh kit • 48 hrs.
Visible 670nm
CDRH class IIIa, IEC class 3R
To international standard IP56
-4º F to +140º F (-20º C to +60º C)
What a difference it makes when you have the right tool.
The Alpha-c saves so much time and effort when the job
calls for a conical slope, that any other method is now
obsolete. By eliminating the labor-intensive calculations
and staking that used to be needed, the Alpha-c can pay
for itself very quickly. The chance for errors is minimal
when you can continuously
check points all over the
slope from a single setup.
Choose the standard
0 to 4% head, or the
finer adjustment capability
of the 0 to 1.7% head
at no additional cost
Simple one button
start-up gets you
working quickly
Each Alpha-c is hand
built and tested by our
engineering team.
The Alpha-c can project a
cone from 0 to 4% slope
either up or down, in
increments of 1/4%. An
optional version projects
a cone from 0 to ±1.7%
slope with even finer
increments of 1/10%.