Product Manual

8 | Electronic Sump Pump Switch
Sump Pump Switch
Electronic Sump Pump Switch
®
®
®
®
®
Fluid Control Products
Install LevelGuard® Sump Pump Switch
WARNING: DO NOT plug in LevelGuard® Sump Pump Switch until instructed to
do so.
1. Drain the sump pit (Recommended).
2. Loop provided tie straps through LevelGuard
Sump Pump Switch holes at top and bottom as
shown in
Detail A. Leave about 3" of slack for ease of
installation.
3. Hold Sump Pump Switch with cord up. Lower into
sump pit.
4. Place bottom of Sump Pump Switch against
discharge pipe, at LOWEST level where you want
water to be pumped. This is where the Sump Pump
Switch turns the pump “OFF”.
NOTICE: If check valve is in the way, you can attach
Sump Pump Control onto the check valve (Detail B).
Mount Sump Pump Control facing AWAY from inlet
pipe.
5. The Switch Point “ON” is 10" (254 mm) above the pump inlet… so water will
rise about 9" before pump turns on.
Detail A
Install LevelGuard-01
Minimum 2"
(5cm) Clearance
UNPLUG
10" Fluid Level
Control Range
“SWITCH OFF” Level
“SWITCH ON” Level
Mount Sump
Pump Control
AWAY from
Inlet Pipe
Check Valve
Inlet Pipe
Discharge Pipe
Discharge Pipe
Tie Straps instal-01
Loop
(2) Tie Straps
Through
Leave 3" of slack for
installation ease
Detail B