Product Manual

ManualsBrandsPro Series ManualsAlarms360° Water Sensor For Pro Series PWA2 Water Alarm

08/2020

Model No.

PWA2

MFD for Glentronics, Inc.

Lincolnshire, IL 60069

Example of multiple 360° Water

Sensors connected to one Water Alarm

Remove the rubber plug

from the 3.5 mm jack to

plug in additional sensors

3.5 mm jack

Installation Instructions

PS-WS360 Water Sensor

360° Water Sensor

This sensor can be connected to a Pro Series Water Alarm or

Pro Series Deluxe Float Controller. Compatible units will have a

3.5 mm jack on the side of the Water Alarm or the bottom of the

Deluxe Controller. When the water reaches the sensor, it will

trigger an audible alarm on the connected device. It can be

placed wherever there is a risk of water damage such as utility

room, laundry room, kitchen, bathroom or basement. DO NOT

USE THIS INSIDE A SUMP OR SEWAGE PIT.

The 360° Water Sensor has patented technology that allows it to

detect water when placed on any side, top or bottom. This allows

it to be placed in any orientation in order to ﬁt into small spaces.

3.5 mm Jack

On the side of the 360° Water Sensor you will ﬁnd a 3.5 mm

jack (Shown in Diagram A ). This allows you to connect more

then one 360° Water Sensor to one Pro Series Water Alarm or

Deluxe Float Controller (Shown in Diagram B ). This will allow

you to monitor multiple locations for water damage. First

remove the rubber plug from the 3.5 mm jack and then plug in

additional sensors.

Maintenance

Each time the 360° Water Sensor is activated with water, it must

be cleaned and retested to ensure it is working properly. If the

360° Water Sensor is continuously alarming after being

submerged in water, that means water might have gotten inside

the 3.5 mm jack. Let it dry for 24 hours and the sensor should

resume normal operation.

Testing the Water Sensor

Make sure the 360° sensor is connected to a Pro Series Water

Alarm or a Pro Series Deluxe Controller. Touch two pairs of

metal pads at either end of the

360°

water sensor with your

ﬁngers. The audible alarm will sound as long as you hold

both ﬁngers on both metal pads (Shown in Diagram C ).

Summary of content (2 pages)

PAGE 1
Installation Instructions PS-WS360 Water Sensor Testing the Water Sensor Make sure the 360° sensor is connected to a Pro Series Water Alarm or a Pro Series Deluxe Controller. Touch two pairs of metal pads at either end of the 360° water sensor with your fingers. The audible alarm will sound as long as you hold both fingers on both metal pads (Shown in Diagram C ). C 360° Water Sensor This sensor can be connected to a Pro Series Water Alarm or Pro Series Deluxe Float Controller.
PAGE 2
LIMITED WARRANTY By opening this package and using this GLENTRONICS, INC. product, you are agreeing to be bound by the terms of the GLENTRONICS, INC. limited warranty (“warranty”) as set out below. Do not use your product until you have read the terms of the warranty. If you do not agree to the terms of the warranty, do not use the product and return it within the return period stated on your purchase receipt from the retail store or authorized distributor where you purchased it for a refund.