Product Manual

Introduction
The Pro Series Pair of Pumps combination system
is designed to provide both primary and backup
pumping capabilities. The primary pump will
operate as long as it is receiving AC power. If
the power is interrupted, or more water is
coming into the sump than the AC pump can
handle, the backup sump pump will begin
pumping automatically. The backup system has
unique monitoring features that diagnose a
problem and sound an alarm. A light on the
display panel of the control unit will indicate the
cause of the alarm and the corrective action.
The two systems have been pre-assembled for
easy installation.
For added reliability, the float switches have, not
one, but two floats. Should one float fail to
operate, the second float will automatically
activate the pump.
The Pair of Pumps Combination Sump Pump
System includes:
• A 1/3 HP primary pump with a caged dual
float switch, and a blue piggyback controller
that plugs into the wall outlet
• A blue backup pump
• A backup control unit with a battery fluid
sensor, a dual float switch, battery cables,
and a 20-amp fuse
• A battery charger
• A battery cap with a hole to accommodate
the fluid sensor
• A battery box
• A no hub coupling
You will also need to supply:
• A Pro Series B-2200 or B12-100 standby
battery.* DO NOT use a Pro Series B-1000
Standby Battery with this system. It will not
run the pump as long as the B-2200 or
B12-100 standby battery.
• DO NOT use an automotive battery with this
system
• A surge protector (recommended - backup
controller only)
• Six (6) quarts of 1.265 specific gravity battery
acid (if using a wet cell standby battery)
*Pro Series standby batteries are specifically
designed to work with your battery backup
sump pump system. Glentronics can not
guarantee the compatibility of other brands
of batteries. For optimal performance the
use of a Pro Series standby battery is
recommended.
For some installations you may need
additional items:
• 1-1/2” rigid PVC pipe to connect to the
existing plumbing
• A PVC pipe connector or a rubber union
• PVC pipe cleaner and cement
To connect two batteries you will need:
• Two (2) batteries of same type, age and
capacity (so they will have equal power and
charge properly). Do not use batteries of
different types, ages or capacities.
• Two (2) acid packs to fill the dry batteries.
Acid packs are not needed if using
maintenance free (AGM) batteries
• A set of battery cables with rings on both
ends to connect the two batteries together
(available from Glentronics, Inc.)
• Another battery box
System Specifications
Power supply requirements.......115 volts, 60 Hz
AC pump pumping capacity..... 2770 GPH @ 10’
............................................. 46 GPM @ 10’
DC pump pumping capacity..... 1850 GPH @ 10’
............................................. 31 GPM @ 10’
Overall dimensions................. 11” W x 23¾” H
Page 2
No Hub
Coupling
Primary Pump Controller
Backup
Pump
Controller
Primary
Pump
Cable Tie
Battery Cap
Backup Pump
Float Switch
Backup
Pump
Battery Box
Primary
Pump Float
Switch
Battery
Wires
Fluid Sensor