Use and Care Manual

CGGUN Cordless Grease Gun Assembly & Operating Instructions
6
BATTERY CHARGER
Unplug the battery power source before assembly, adjustments, or adding/removing accessories.
Use only the undamaged NiCd type Battery Pack. Do not charge a cracked, open, or leaking Battery Pack.
The Battery Pack’s terminals will fit this Charger only. Do not use the Battery Pack if it does not fit the Charger. Do not force a Battery Pack into
the Charger.
Plug the Charger Power Cord into a grounded, 120 VAC, 60 Hz receptacle. Do not use an extension cord.
A Green LED will light when the power is connected. It will remain on during the charging process when the cord is connected.
Position the Battery Pack into the Charger. The Red LED will flash to show the Battery is charging.
The Battery Pack and Charger may become warm to the touch during charging.
Allow the Battery Pack to Charge for 1 hour. The Red LED will light continuously when the Battery Pack is charged.
Unplug the Charger and disconnect it from the Battery Pack when finished.
GREASE GUN OPERATION
Unpack product from package and review contents. Keep all packaging until product has been reviewed.
Loading the Grease Gun with a Grease Cartridge
1. Turn the screw counterclockwise to open the Vent Valve.
2. Grip the Follower Rod Handle and pull it until the Follower Rod is extended. Pull the Follower Rod sideways to latch it into the slot on the end
cap of the Grease Tube, locking it open.
3. Remove the Grease Tube from the Pump Housing.
4. Remove the plastic cap from a grease cartridge (not included), and insert the cartridge into the Grease Tube.
5. Remove the pull tab from the grease cartridge and screw the Grease Tube back into the Pump Housing.
Release the Follower Rod from the slot on the end cap of the Grease Tube to allow the Follower Rod to move forward into the Grease Tube.
7. Once the Grease Gun is loaded, prime Gun and expel any air pockets as follows:
a. Close the Vent Valve.
b. Squeeze the Trigger several times to operate the Grease Gun until any trapped air is expelled and grease flows smoothly from the Coupler.
c. Push the Follower Rod all the way into the Grease Tube. Gun is now primed and ready for use.
Loading the Grease Gun from a Bulk Container
1. Unscrew and remove the Grease Tube from the Pump Housing.
2. Insert the open end of Grease Tube into lubricant. Slowly pull the Follower Rod back while pushing the Grease Tube deeper into the
lubricant to prevent air pockets from being pulled into the Grease Tube.
3. When the Follower Rod is fully extended, pull it sideways to latch the Rod into the slot on the end cap of the Grease Tube, locking it open.
4. Screw the Grease Tube into the Pump Housing.