Use and Care Manual

!
2!
PACKAGE CONTENTS:
Regularly clean clothes dryer vent systems to ensure the safe operation of your dryer. When attached to a cordless drill, the rotating action
of the auger brush and flexible rods scours the vent to effectively clean the dryer vent system.
You may also choose to use this to clear gutter downspouts, under the refrigerator, and baseboard heaters.
NOTE: Extra care must be taken when cleaning white vinyl or foil dryer vents, as these can tear easily.
Not all vents can be cleaned. Check dryer vents 3-4 times per year.
ASSEMBLY
Nylon Rods:
To connect the rods, screw them together and tighten with two pairs of pliers.
Use a small piece of electrical tape or duct tape around the joint of the fittings after tightening.
The fittings on the rods are designed to fit into any type of cordless drill without an adapter.
Insert the steel rod fitting into the chuck of the drill and tighten by hand.
Twist chuck to tighten.
Depending on your project, you may attach either the Lint Trap Brush or the Auger Brush or the Blockage Removal Tool.
Auger Brush:
Screw Auger Brush onto rod and tighten. Insert set screw into threaded hole in Auger Brush fitting and tighten using included hex key.
(Use 8-32 x 1/8”L set screw if replacement is needed)
Lint Trap Brush:
Screw Lint Trap Brush onto rod then tighten with two pairs of pliers.
Use a small piece of duct tape on joint to help reduce the risk of brush unscrewing from rod.
Blockage Removal Tool:
Place the Blockage Removal Tool onto the rod.
Thread the included nut onto the rod. Tighten with pliers or wrench.
4 - 36" long Flexible Nylon Rods
1 - 4" Auger Brush
1 - 2.5" Lint Trap Brush
1 - Blockage Removal Tool
2 - Vacuum Adapter
1 - Dryer Adapter
1 - Drill Adapter
!