Use and Care Manual

8. Remove Suction Tube from water or flushing
solvent and submerge in paint pail.
9. Switch Power to On.
10.
Paint should work itself from Suction Tube to Sprayer
to Priming Tube until paint discharges from Return
Tube. Point gun into waste bucket and pull trigger.
11.
Turn Spray/Prime Switch to Spray mode and
continue to spray into waste bucket.
12.
Stop spraying and activate trigger lock.
13.
Remove the Priming Tube from the waste bucket and
clip to Suction Tube and submerge in paint pail.
14. If the motor stops, the pump and tubes are primed.
If it does not stop, repeat priming steps.
15. Start Painting.
Page 12
ITEM # APS517 Airless Paint Sprayer Operating Instructions
ON