Warranty

Item # DRNAGS Drain Cleaner Manual

Forward – Neutral – Reverse

Handle Grip

HELPFUL TIPS

1. Place the tool head at a distance of less than 6 inches away from the pipe opening. If the distance is too long,

it will cause the flexible shaft to be twisted and knotted. Do not place the tool head too close to the pipe, which is

inconvenient to observe the condition of the flexible shaft.

2. Press the forward and reverse rotation button L, press the speed switch slightly, pull the handle forward to the

F position, and the flexible shaft will move forward to start cleaning; after cleaning the pipe, pull the handle back

to the R position to retract the flexible shaft.

3. In the case of blockage or blocked cornering of the flexible shaft, pull back the handle to retract for a certain

distance, and then pull forward to deliver again. Repeatedly move forward and backward the operating handle to

dredge the pipe and move through the corners. Do not force the delivery of the flexible shaft, otherwise the

flexible shaft will twist knotted or be broken and cause serious injury.

4. If the blockage is too stubborn, apply the following two methods:

1) Rotate the locking ring counterclockwise to obtain a greater thrust. In this case, it is necessary to lightly

press the speed switch to closely observe the state of the flexible shaft. If the flexible shaft is obstructed,

twisted or knotted, release the speed switch immediately and stop the rotation. Do not force the delivery of

the flexible shaft.

2) Switch the operating handle in F and 0 positions, and dredge the pipe slowly according to the actual

situation. Whether the pipe has been dredged or cannot be dredged, you need to rotate the locking ring

clockwise, loosen the jaw, and retract the flexible shaft by the automatic scaling function.

5. If the flexible shaft is trapped in the pipe (it cannot dredge or be retracted), press the forward and reverse

rotation button R, and pull the handle forward to retract the flexible shaft.

NOTE: It is necessary to closely observe the situation of the flexible shaft when using it. If it is distorted or

blocked, stop the machine immediately, then take different operations according to the actual situation. If the

pipe cannot be dredged, ask for professional for help. Do not force the operation.

Shaft Replacement Instructions

1. Place the operating handle in the O position;

2. Take out the flexible shaft to expose the connector;

3. Unscrew the M4 set screws with an Allen wrench and remove the unwanted flexible shaft;

4. Insert the new flexible shaft into the connector, align the screw holes, and tighten the M4 set screws again;

5. Push the flexible shaft manually to the inside of the drum.

Do not start the tool to retract the flexible shaft, because the exposed flexible shaft can lead to unpredictable

personal injury, tool damage, damage to indoor objects, fire, electric shock and other dangerous situations.

If the flexible shaft cannot be replaced normally, please send it to the designated service center for repair.

Storage and Maintenance

After use, position the tool with the head down, so that the liquid inside the drum can flow out.

(A) (B)

Manually rotate the drum to reveal the waterproof plug (A), then remove it with a hex wrench (B).

Clean the flexible shaft and drum carefully. If it is not to be used for a long time, please apply light lubricant on

the surface of the flexible shaft to prevent rust.