Warranty
Item # DRNAGS Drain Cleaner Manual
2
ITEM # DRNAGS
FEATURES:
• Volt / Frequency: 120V 60 Hz
• Speed: 0-560 RPM
• Flexible Cable: 25 Feet (L) x 1/4"
• Ideal for cleaning 3/4" - 2" Kitchen/ Bathroom Pipe
• 300 Watts/ 2.3 Amps
• Forward/Reverse
• 12 Ft. Electric Power Cord
• Auto Feed
• Variable Speed
• Corrosion-resistant PE drum
• GFCI
WARNING: Read the following guidelines carefully!
1. Do not wear soft gloves or use a cloth towel to hold the rotating flexible shaft. If rotating, it may cause serious
injury if twined in the flexible shaft.
2. Do not over-deliver the flexible shaft. May cause it to wind or break off and cause serious injury.
3. Do not operate the machine while reversing (pressing the reverse rotation button (R). Operating in the
Reverse (R) state can cause damage to the flexible shaft. Only use it to retract the cable.
4. If using detergent in the pipe, avoid direct contact with skin or eyes. Some detergents can cause severe
burns.
5. The function of this tool is to clean and clear the pipes. Do not use for any other purpose. This is not a toy.
6. Do not use the tool when the handle, switch, grounding plug or fuse is damaged. Poorly maintained tools can
cause serious injury.
Check Before Operation
1. Make sure the plug is unplugged.
2. Make sure the cable plug is undamaged.
3. Check if there are damaged machine parts that may pose a threat to your safety.
4. Selection of appropriate accessories for pipe dredge can improve the efficiency and quality of dredging.
5. Before using, clean up the dirt on handle and the machine body.
6. Check if the flexible shaft is worn or damaged. If needed, replace it immediately.
6. Check the workplace to ensure sufficient lighting, no flammable liquid, gas or dust.
8. Do not place the side of the flexible shaft towards the operator or other people.
9. Insert the plug into the socket, and confirm that the dredger can easily approach the pipe opening, if the
distance is too long, add extension cord.
10. When using the power tool outdoors, use extension cords marked with “W-A” or “W \” and the wire insulation
layer must be thick enough. These cords are suitable for outdoor use and can reduce the occurrence of electric
shock.