Specifications

4.2 CPR
When there is an emergency to perform
CPR on the patient, quickly pull the CPR
valves to release air from mattress. The
CPR valves are located at the head-end,
right-hand-side of the mattress. The
quick connector on the pump unit can
be disconnected for faster deflation.
4.3 Pressure Set Up
Users can adjust pressure of air mattress to a desir
e
d softness
by adjusting the pressure knob. Please consult your physician
for a suitable setting.
Patient can lie on the mattress after Normal Pressure indicator
lights up, this indicates the pressure is reached to the desired
softness.
NOTE: Check to see if the suitable pressure is selected by
sliding one hand between the deflated air cells and
the patient to feel's patient's buttock. Users should be
able to feel the minimum
4.4 Low Pressure and Alarm Function
When an abnormal low pressure occurred, the Low Pressure in-
dicator (yellow LED) will light up. Check to ensure all connec-
tions are connected properly and that they are correctly installed
as per installation instructions.
NOTE: If the pressure level is consistently low, check for any
leakage (tubes or connecting hoses). If necessary,
replace any damaged tubes or hoses. Or, contact
local qualified dealer for repair.
The pump unit is equipped with alarm buzzer, the alarm will
buzz and the Low Pressure indicator light up when air pressure
is below normal. To mute the alarm, simply press the Alarm
Reset button on the side. However, the low pressure indicator
remains until the low-pressure fault condition is resolved.
Note :To re-activate the audible alarm function, please press
Alarm Reset button again on the side to turn on the function.
2. Normal Pressure Indicator - When green LED lights up, the pres
sure inside of air mattress reaches the preset pressure setting.
3. Low Pressure Indicator - When low pressure LED lights up, the
pressure inside of air mattress is below normal. Please refer to
troubleshooting.
4. Static Function - Press orange STATIC button to suspend alternat-
ing function, if needed. The pressure inside of air tubes will be
adjusted to the same softness. Press the STATIC button again, it
will switch back to alternating mode.
3. Installation
U
n
packing the box to inspect for any damage which may have oc-
curred during shipment. If there are any damages, please contact
your dealer immediately.
3.1 Pump & Mattress Installation
1. Place the mattress or pad on
top of the bed frame. Please
note for the foot end.
2. Hang the pump onto bed rail
(foot-end), and adjust hangers
to best upright position of the
pump or place the pump on a
flat surface.
9 6