Specifications
1.
Introduction
This manual should be used for initial set up of the system and for refer-
ence purposes.
1.1 General Information
The system is a high quality and affordable mattress system suitable for
stage I, II bed sore treatment and prevention of pressure ulcers.
The system has been tested and successfully approved with the following stan-
dards:
1.2 Intended Use
This product is intended to help and reduce the incidence of pressure
ulcers while optimizing patient comfort. It also provide following
purposes:
• Individual home care setting and long term care of those
suffering from pressure ulcers.
• Pain management as prescribed by physician.
NOTE : Equipment not suitable for use in the presence of a flammable
anesthetic mixture with air or with oxygen or nitrous oxide.
9. Troubleshooting
PROBLEM SOLUTION
Power is not on
♦ Check to see if the plug is connected to the
wall outlet.
♦ If the wall outlet is connected to a wall switch,
make sure the switch is turned on.
♦ Check breaker box for a blown breaker or fuse.
Alarm is on
(Audio & Visual)
♦ Check to ensure connection between air tube
connector and the pump is secure.
♦ Check CPR valve to ensure it is sealed.
♦ Check Air Cells for leakage.
Patient is bottoming out
♦ Pressure setting on the pump may be too low
for the weight of the patient - Adjust pressure
to higher setting and check again after a few
minutes...repeat until patient is adequately
supported.
♦ Check Air Cells for leakage.
Air Mattress is not
secured
♦ Check all of the snap buttons that secure the
individual air cells to the mattress cover to
ensure they are all securely fastened.
♦ Check to ensure the mattress is properly
secured to the bed frame by the elastic straps.
No air is being produced
from some of the air
outlets of the air tube
connector
♦ This is normal during use under Alternating
Mode. Air outlets cycle intermittently.
If your questions can't be answered with above information, it might require a
technician to take care the problem. Please contact your local agent directly.
Mattress Specification
Dimensions (LxWxH)
78.7” x 35.4” x 8”
Weight 12.4 lbs.
Pressure Range 30 - 50 mm Hg
3 12