Alternating Pressure Mattress System Apex Medical (Kunshan) Corp. No. 1368, Zi Zhu Rd., Kunshan Kai Fa Hi-Tech, Kunshan City, JiangSu Sheng, China MADE IN CHINA Pmi, Inc. 15 South Main Street Marlboro, NJ 07746 Please Read Instructions Before Use IN 596001-6130 V1.
Contents LIMITED WARRANTY Important Safeguards 2 Introduction 3 Product Description 4 Installation 6 Operation 8 Cleaning 10 Storage 10 Specifications 11 Troubleshooting 12 Grounding Instructions 13 Limited Warranty 14 PLEASE NOTE: THE WARRANTY BELOW HAS BEEN DRAFTED TO COMPLY WITH FEDERAL LAW APPLICABLE TO PRODUCTS MANUFACTURED AFTER JULY 4, 1975. This warranty is extended only to the original purchaser/user of our products.
ELECTRICAL REQUIREMENT IMPORTANT SAFEGUARDS GROUNDING INSTRUCTIONS READ ALL INSTRUCTIONS BEFORE USING This product should be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. This product is equipped with a cord having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded.
Mattress 1. Introduction This manual should be used for initial set up of the system and for reference purposes. 1.1 General Information The system is a high quality and affordable mattress system suitable for stage I, II bed sore treatment and prevention of pressure ulcers. Specification Dimensions (LxWxH) 78.7” x 35.4” x 8” Weight 12.4 lbs. Pressure Range 30 - 50 mm Hg 9.
7. Maintenance 2. Product Description 7.1 General 1. Check main power cord and plug if there are abrasions or excessive wear. 2. Check mattress cover for signs of wear or damage. Ensure mat tress cover and tubes are stubbed together correctly. 3. Check airflow from the air hose connector. The airflow should alternate between each connector every half-cycle time if it's in alternating mode. 4. Check the air hoses for any kink or break. For replacement, please contact an authorized dealer. 2.
2.2 Pump Unit 4.5 Static Mode Front 1. Quick Connectors If the pump unit is equipped with STATIC function, press the Orange STATIC button to suspend the alternating mode of mattress. By pressing this button again, the mattress will be back to alternating therapy mode. 2. Alarm Reset 3. Front Panel 5. Cleaning It is important to follow the cleaning procedures before using the machine on human bodies; otherwise, patients and/or doctors may have the possibility of getting infection.
4.2 CPR When there is an emergency to perform CPR on the patient, quickly pull the CPR valves to release air from mattress. The CPR valves are located at the head-end, right-hand-side of the mattress. The quick connector on the pump unit can be disconnected for faster deflation. 2. Normal Pressure Indicator - When green LED lights up, the pres sure inside of air mattress reaches the preset pressure setting. 3.
3. Connect air hose connectors from Air Mattress to the pump unit. When a "click" sound is felt or heard, the connection is completed and secured. 4. Operation Note: Always read the operating instruction before use. 4.1 General Operation Note: Check and ensure the air hoses are not kinked or tucked under mattress. 4. Plug the power cord into electrical outlet. Note: 1.Make sure the pump unit is suitable for the local power voltage. 2. The plug is also served to disconnect the device. 1.
