User's Manual

B/G Protection: User can choose from Auto, On, and Off

Î Auto: STA will dynamically change as AP announcement

Î ON: Always send frame with protection.

Î Off: Always send frame without protection.

TX Rate: Manually force the Transmit using selected rate. Default is auto.

Tx Burst: Frame burst mode.

HT Physical Mode: Configure HT Status in use, containing HT(MM or GF), BW(20 or Auto),

GI(Long or Auto), and MCS(0~15, 32, or Auto) settings.

[QoS] The QoS configuration page can allow you to configure WMM and Direct Link settings

(1) QoS Configuration

WMM: Enabe Wi-Fi Multi-Media.

WMM Power Saving: Enable WMM Power Save.

PS Mode: Select which ACs you want to enable.

Direct Link Setup: Enable DLS (direct Link Setup).

(2) Direct Link Setup

MAC Address: Fill in the blanks of Direct Link with MAC address of STA. Connect with the

same AP that supports DLS features

Timeout Value: Timeout Value represent that it disconnect automatically after some seconds.

The value is integer. The integer must be between 0~65535. It represents that it always