User's Manual

11
STEP8:Afterthesetupwizardhas successfullyinstalledwirelessLAN,clickFinishtoexitthe
wizard.

The Configuration Utility appears as an icon on the system tray of Windows while  the
adapterisrunning.Youcanopentheutilitybydouble‐clickontheicon.


Right‐clicktheicon, therearesomeitemsforyoutooperatetheconfigurationutility,
z LaunchConfigUtilitiesÆSelectthisoptiontoopentheConfigurationUtilitytool.
z Use Zero Configuration as Configuration utility (Available on Windows XP only)
Æ
Select this option to use Windows XP built‐in wireless configuration  utility (Windows
ZeroConfiguration)toconfiguretocard.
z SwitchtoSTA+APMode(AvailableonWindows7)
ÆSelectthisoptiontochangeto
APmode.
z SwitchtoAPMode(AvailableonWindowsVista/XP/2000only)
ÆSelectthisoption 
tochangetoAPmode.
z Open Diagnostic Testing Mode (Available on Windows Vista/XP/2000 only)
Æ To
checknetworkconnectionstatus.
z ExitÆSelectExittoclosetheConfigurationUtilitytool.



