User's Manual

30
[Definitionofeachfield]
Sorted by >>: You can decide how to sort all listed access point by SSID, Channel, Signal
(Signalstrength).
Show dBm: Check this box to show the signal strength of access point, instead of
percentage.
Rescan:Clickthisbuttontorescanaccesspoints.Youcanclickthisbuttonforseveraltimes
,
iftheaccesspointyouwishtousedoesnotshowinthelist.
AddtoProfile:Youcanstoreaspecificaccesspointtoprofile,soyoucanlinktothataccess
pointdirectlynexttimewithoutinputtingauthenticationkeyagain.
Connect:Connecttoaselectedaccesspoin
t.Youhav etoselectanaccesspointfromthelist
firstandthenclick“Connect”toconnecttotheselectedaccesspoint.

[Icons&Buttons]
 ÎIndicateconnectionissuccessful.
 ÎIndicatenetworktypeisinfrastructuremode.
 ÎIndicatenetworktypeisAd‐Hocmode.
 ÎIndicatesecurity‐enabledwirelessnetwork.
 ÎIndicate802.11awirelessmode
 ÎIndicate802.11bwirelessmode.
 ÎIndicate802.11gwirelessmode.
 ÎIndicate802.11nwirelessmode.
 ÎIndicate the
APlistsaresortedbySSID,Channel,orSignal.
 ÎCommandtoconnecttotheselectednetwork.
 Î Issue a rescan command to wireless NIC to update information on
surroundingwirelessnetwork.
 ÎAddthe selectedAP toProfilesetting.Itwillbringupprofilepageand
saveuser’ssettingtoanewprofile.

[ConnectedNetwork]
(1) WhenRaUIfirstran,itwillselectthebestAPtoconnectautomatically.