User's Manual

Step9: The Detail screen will look like the below figure.

*If Credential#1 is reliable and present, system will connect with Credential#1. On the contrary,

system will auto rotate to the next exist credential.

*Also you can click “Rotate” button. Command to rotate to the next credential you want to use.

3.7.2 To Add to AP using PBC Method

The PBC method requires the user to press a PBC button on both the Enrollee and the

Registrar within a 2-minute interval called the WALK TIME. If ONLY ONE Registrar in PBC

mode, which PBC mode is obtained from ID 0x0004, is found after a complete scan, the

Enrollee can immediately begin running the Registration Protocol.

If the Enrollee discovers more than one Registrar in PBC mode, it MUST abort its

connection attempt at this scan and continue searching until 2-minute timeout.

z Before you press PBC on STA and candidate AP, make sure all of APs aren’t PBC mode

or APs using PBC mode have left their Walk Time.

z Recommend you to do Disconnect and Delete first before each configuration setup.

Step1: Click PBC to start PBC connection.

Step2: Push PBC on AP.