User's Manual

Tx BURST: The Burst enables the adapter to deliver the better throughput in the same period

and environment.

Enable TCP Window Size: The TCP Window is the amount of data a sender can send on a

particular connection before it gets an acknowledgment back from the receiver that it has

gotten some of it. When the Router or AP card is connecting to have set up the TCP Window,

you can enable the parameter to meet the data size for the Router or AP connection. The

larger TCP Window the better performance.

Fast Roaming at: You can enable the parameter when you want to fast roaming to the

network nearby without intercepting the wireless connection, especially the adapter is applied

to the multimedia application or a voice call. The adapter will fast roaming to the near network

when the receive sensitivity (signal strength) is lower to the value you have set up.

Show Authentication Status Dialog: When you connect AP with authentication, choose

whether show “Authentication Status Dialog” or not, Authentication Status Dialog display the

process about 802.1x authenticatin.

Turn Off/on RF Button: If you want to turn off the radio of the adapter temporarily, click this

button. To turn on the radio, click this button again.

Enable CCX: CCX (Cisco Compatible Extensions) is developed by Cisco for the radio

monitoring and fast roaming.

(1) LEAP turn on CCKM.

(2) Enable Radio Measurement: can channel measurement every 0-2000 milliseconds.

Turn on CCKM: During normal operation, LEAP-enabled client devices mutually authenticate

with a new access point by performing a complete LEAP authentication, including

communication with the main RADIUS server.

When you configure your wireless LAN for fast re-association, however, LEAP-enabled

client devices roam from one access point to another without involving the main server. Using

Cisco Centralized Key Management (CCKM), and access point configured to provide Wireless

Domain Services (WDS) takes the place of the RADIUS server and authenticates the client so

quickly that there is no perceptible delay in voice or other time-sensitive applications.

Enable Radio Measurement: When this parameter is enabled, the Cisco AP can run the radio

monitoring through the associated CCX-compliant clients to continuously monitor the WLAN

radio environment and discover and new APs that are transmitting beacons.

Non-Serving Channel Measurements: The Cisco AP can perform monitoring measurements

through the CCX-compliant clients on the non-serving channels when this parameter is

enabled.

Limit xxx milliseconds (0-2000): It limits the channel measurement time. The default value is

250 milliseconds.