User's Manual

Wireless Mode: User can select which wireless standard network uses.

You can choose from “802.11 B/G mixed mode” and “802.11 B only”.

Enable TX burst: Enable data burst mode during data transmission.

Ad Hoc mode use OFDM rate: In Ad Hoc mode network uses OFDM

data transmitting standard.

11B/G Protection: User can choose from Auto, ON and OFF.

Auto: Allows network to transmit data via 11B or 11G mode under

different scenarios.

TX Rate: Allows user to choose data transmission rate.

Auto: Data transfer rate will automatically set to 1Mbps, 2Mbps,

5.5Mpbs, 11Mbps, 6Mbps, 12Mbps, 18Mbps, 24Mbps, 36Mbps,

48Mbps or 54Mbps under different transmission condition.

You can also set a fixed transfer rate at 1Mpbs, 2Mbps, 5.5Mpbs,

6Mbps and 11Mbps.

RADIO OFF: Allows user to turn on of off device antenna.

APPLY: Save the settings you select.

3.1.6 User can launch Ralink Configuration Utility, select country or

uninstall device driver by clicking “Start

Æ Wireless LAN Card”.