User's Manual

55
Enable -- Check to enable the selected route or route to be added.
Destination -- The network IP address of the subnet. The destination can be specified as the
IP address of a subnet or a specific host in the subnet. It can also be specified as all zeros to
indicate that this route should be used for all destinations for which no other route is defined
(this is the route that creates the default gateway).
Subnet Mask -- The network mask for the destination subnet. The default gateway uses a
mask of 0.0.0.0.
Next Hop -- The IP address of the next hop through which traffic will flow towards the
destination subnet.
Metric -- Defines the number of hops between network nodes that data packets travel. The
default value is 0, which means that the subnet is directly one hop away on the local LAN
network.
Interface -- The WAN interface for a static routing subnet is to be applied.
Add Route -- Add a user-defined destination route.
Update -- Update the selected destination route on the Static Route Table.
Delete Selected -- Delete a selected destination route on the Static Route Table.
Show Routes -- Click this button to view the DSL device’s routing table.
4.7.4 SNMP
Simple Network Management Protocol (SNMP) is a troubleshooting and management protocol