Operating instructions

3 -

1. Electrical standards

The electrical standard corresponds to the safety regulations

concerning the European standard EN 61010 and DIN

57721 for testing the voltage of heater elements.

2. Safety instructions

Please note the following basic safety procedures when using

this equipment:

• Read these operating instructions carefully before start-up

and use of the equipment. The information and warnings

given in these operating instructions must be heeded.

• Attention must be paid to the requirements of IEC 364 (DIN

VDE 0100) when setting high-power electrical units with

nominal voltages of up to 1000V, together with the

associated standards and stipulations.

• Work on electrical equipment is only to be carried out by

trained specialists as per the regulations currently in force.

• Check the details on the type plate to ensure that the equipment

is connected up to the correct mains voltage.

• Protection against touching dangerously high electrical

voltages. Before opening the equipment, it must be switched

and hold no voltages. This also applies to any external control

circuits that are connected.

• The equipment is only to be set within the permitted range of

temperatures and pressures.

• The CG-10 is packaged in an enclosed purgeable

instrument case, directly suitable for installation in most

General Purpose classified areas. Operation in hazardous

atmospheres may require case purging, pressure interlocks,

additional enclosures or other protective devices. It is the

responsibility of the operator to insure compliance with

additional requirements for service in hazardous

atmospheres.

• Installation, maintenance, monitoring and any repairs may

only be done by authorized personnel with respect to the

relevant stipulations.

M&C Products Analysis Technology

9-2.0-MEUS