User`s guide

3.7 Checking Bed Status
The delay will count down on the display. If an Infinite delay has been
set up, the session time will show but will not count down. DELAY
will show for status. Once the customer presses the Start/Stop button
on the T-Max® 3A in the room, the session will start. The display will
show the session time counting down and the status will stay ON.
To check the status of a bed, glance at the 64 dual colored lights.
Green
= Bed is ready for a new session.
Red
= Bed needs to be cleaned.
Off
= Bed is not available.
3.4 Canceling A Session
Flashing Red = There are less than two minutes left in a session.
Flashing Green = Bed is in the Cool Down Mode.
Yellow = Scanning or Error.
1) Press the BED NUMBER that you want to cancel, followed by the
ENTER button.
To check time remaining in an active session, press the bed number
followed by Enter.
To check the times on all beds, press the Next or Prev (previous) button
repeatedly.
2) Press the TIME button. The message “Enter the Time” will appear on
the VFD display.
The session will start and the display will show the bedtime and status.
3) Press the ENTER button (without entering any time).
If the clean room is enabled and the delay time has expired, DIRTY
will appear on the display the Status LED will be red. Once the clean
room signal has been cleared, the display on the T-Max® Mgr/Pro will
show READY and the Status LED will turn green.
3.8 To add T-Max® Mgr/Pro’s
1) The side of the T-Max® Manager/Pro has 2 terminator switches. Flip
these two switches up to the OFF positions on each slave T-Max®
Mgr/Pro.
3.5 Pausing A Session
2) Apply power to each Slave T-Max® Mgr/Pro.
To pause a session, press the START/STOP button on the T-Max® 3A at
the tanning bed. The flashing period will stop flashing and stay illuminated.
The T-Max® Mgr/Pro display will show PAUSE on the display.
3) Make sure each Slave T-Max® Mgr/Pro has a unique address.
4) Connect each slave T-Max® Mgr/Pro where you want in the daisy.
Note: The session time will continue to count and the display will reflect
the remaining session time.
5) Apply power to the Master T-Max® Mgr/Pro.
6) Refer to Section 3.2.1.9 and Set the Max. Slave Setting on the Master T-
Max® Mgr/Pro.
To restart the session, press the START/STOP
button on the T-Max® 3A.
The period will continue flashing and the Status on the T-Max® Mgr/Pro
will change to ON.
7) Cycle power to the Master T-Max® Mgr.
3.6 Clean Room
Each Slave T-Max® Mgr/Pro must be powered up
before you power the Master T-Max® Mgr/Pro. Each Mgr/Pro
can be used to cancel a session, start a session, and monitor all
sessions. However, parameters (bulb hours, session counts, etc.)
can only be monitored and changed from the Master T-Max®
Mgr/Pro.
Once the session time is over, the display will show two periods with no
numbers, which is an indication that the room needs to be cleaned. To clear
the clean room signal, press and hold the Up Arrow button on the T-max 3-
A until the timer beeps and shows 0.
T-Max® Manager/Pro and T-Max® 3A User’s Guide Page 13 T-Max® Manager/Pro and T-Max® 3A User’s Guide Page 14