User`s guide
3
SETTING UP THE MANAGER/PRO
WITHOUT A COMPUTER.
If you want the session to start right away,
enter a delay of 0. The maximum setting for
delay is 10 minutes. This setting is for
every bed in the salon.
7) The following message will appear: MGR START MODE. Enter the
desired Auto Start Mode followed by the ENTER button.
This setting is for every bed in the salon.
3.1 Description
If a
0
is entered, the bed will not come on automatically when the
delay time expires, but session time will begin counting down (the 0
will not appear on the display). The Start button must be pressed in the
room, for the bed to come on.
The T-Max® Mgr/Pro has 64 dual-colored lights showing bed status.
A 16x2 VFD display on the upper right corner of the T- Max® Mgr/Pro
shows bed status and times. A 16-key keypad allows the user to control the
salon.
If a
1
is entered, the bed will come on immediately after the delay time
expires.
3.2 Initial Configuration
If a
2
is entered, then the T-Max® Mgr/Pro is set to infinite delay and
session will not start until the Start/Stop button is pressed on the T-
Max® 3A.
3.2.1 Setting up the T-Max® Mgr/Pro.
1) Apply power to the T-Max® Mgr/Pro. The T-Max® Mgr/Pro will scan
the network to find all T-Max® 3As.
2) Press the Call/Menu button. The following message will appear:
SECURITY#.
If the T-Max® Mgr/Pro is controlled
by a computer, the Delay and Auto Start
mode are controlled by the computer’s
software - unless you set the Infinite Delay.
If the T-Max® Mgr/Pro is set to Infinite
Delay, the Delay time set in the T-Max®
Mgr/Pro or the PC will be ignored.
A sheet was provided showing the factory
default settings for each security level and
security level descriptions. You must go to
security level 3, and enter that security #.
3)
The following message will appear: GET PARAMS? Press NEXT
4) The following message will appear: SEND PARAMS? Press NEXT
5) The following message will appear: MGR PARAMS? Press ENTER
8
)
The following message will appear: MGR MAX BED. Enter the
maximum bed number followed by the ENTER key.
6) The following message will appear: MGR DELAY TIME. Enter the
delay time in minutes, followed by the ENTER button.
T-Max® Manager/Pro and T-Max® 3A User’s Guide Page 7 T-Max® Manager/Pro and T-Max® 3A User’s Guide Page 8