Specifications

tension 9 Evolution · Revision 2014.01.24

To adjust the feet, turn the small locking screw placed in the upper part of the feet about 180 degrees.

Then screw the upper part by the screwdriver down to make the feet stronger.

Please note: Every feet is pre-adjusted from the factory to the correct position. The picture bellow

is shown only for example, every feet has different inside construction. The turntable was

balanced in the factory before packing. Please adjust the feet only if it’s necessary and watch out

for the correct position.

Fit the drive belt (3) around the platter (4) and the smaller diameter part of the motor pulley (2).

Avoid getting sweat or grease on the belt as these will deteriorate the performance and reduce the belt's

lifespan. Use absorbent kitchen paper to remove any oil or grease from the outer edge of the hub and

the belt.

Put the pulley cover on its rests.

Please note: We recommend to use the record player without a mat on the platter.